Warm air is humidified when it passes over the water in the tray. If the Function Lock is engaged while the unit is off, then all buttons will be disabled.ĭo not remove the bottom trim panel or the humidifier tray while warm air is flowing. If the Function Lock is engaged while the Seconds will disengage the function lock. Press the Function Lock button to activate This feature locks the buttons to prevent The intent of this mode is to save energy. This could result in the temperature setting being reduced by a
After another 30 minutes the temperature setting is reduced another 2☏. This results in the temperature setting being reduced by 2☏, 30 minutes after the room temperature has reached the temperature setting. Pressing the Economy button will cause the appliance to go into Economy Mode and the green lamp will glow. The thermostat automatically modulates the burner and the fan to maintain the temperature setting. After 10 seconds the display will return to showing the room temperature. Continue to press the control buttons until the desired temperature setting is reached. The “Set Temp” should light up and the display will show the current temperature setting. To change the temperature setting press one of the temperature control buttons once. The display will then show the room temperature. When the appliance is turned on the temperature setting will be displayed for 10 seconds. The temperature setting and the room temperature are indicated by the L.E.D. The fan will continue to run for a short time to prevent the internal components from overheating. This is normal and is due to the thermal expansion or contraction of its components. The appliance may make noises after ignition or when it is turned off. There may be a smell of burning dust or oil the first time the heater is lit or when the heater has been out of operation for a long time. This may occur when using the appliance for the first time or if it has not been used for a while.
RINNAI ENERGYSAVER RHFE 263FA N BLINKING 12 CODE
If ignition does not occur after 15 seconds, the appliance will automatically turn off and a fault code will be displayed on the control panel.
When the main burner has lit, the combustion lamp will glow red, and the spark will stop. This heater has an automatic ignition system. When you press the ON/OFF button, the LED display will illuminate, the combustion fan will begin to run, and the spark will ignite the main burner. The efficiency rating of this appliance is a product thermal efficiency rating determined under continuous operating conditions and was determined independently of any installed system. Therefore, specifications are subject to change without prior notice. Rinnai is continually updating and improving products. The flue must be terminated to atmosphere with only flue components listed LPG) when provision is made for the simple conversionfrom one gas to theįorced combustion, forced convection, flued gas furnace įor manufactured home (USA only) or mobile home or residential installationĬonvertible for use with natural gas and liquefied petroleum gases (propane /
įlue Manifold Installation.Įxtension Kit Installation. Gas Connection.Ĭlearances to Combustibles. Īdding Water to the Humidifier.Īdjusting Air Flow Direction. Safety Features.Īppliance Specifications.
0 kommentar(er)
